Recycling of organic materials and solder from waste printed circuit boards by vacuum pyrolysis-centrifugation coupling technology

Here, we focused on the recycling of waste printed circuit boards (WPCBs) using vacuum pyrolysis-centrifugation coupling technology (VPCT) aiming to obtain valuable feedstock and resolve environmental pollution. The two types of WPCBs were pyrolysed at 600°C for 30 min under vacuum condition. During the pyrolysis process, the solder of WPCBs was separated and recovered when the temperature range was 400-600°C, and the rotating drum was rotated at 1000 rpm for 10 min. The type-A of WPCBs pyrolysed to form an average of 67.91 wt.% residue, 27.84 wt.% oil, and 4.25 wt.% gas; and pyrolysis of the type-B of WPCBs led to an average mass balance of 72.22 wt.% residue, 21.57 wt.% oil, and 6.21 wt.% gas. The GC-MS and FT-IR analyses showed that the two pyrolysis oils consisted mainly of phenols and substituted phenols. The pyrolysis oil can be used for fuel or chemical feedstock for further processing. The recovered solder can be recycled directly and it can also be a good resource of lead and tin for refining. The pyrolysis residues contained various metals, glass fibers and other inorganic materials, which could be recovered after further treatment. The pyrolysis gases consisted mainly of CO, CO(2), CH(4), and H(2), which could be collected and recycled.     

Influences on Wood Load in Mountain Streams of the Bighorn National Forest,Wyoming, USA

We documented valley and channel characteristics and wood loads in 19 reaches of forested headwater mountain streams in the Bighorn National Forest of northern Wyoming. Ten of these reaches were in the Upper Tongue River watershed, which has a history of management including timber harvest, tie floating, and road construction. Nine reaches were in the North Rock Creek watershed, which has little history of management activities. We used these data to test hypotheses that (i) valley geometry correlates with wood load, (ii) stream gradient correlates with wood load, and (iii) wood loads are significantly lower in managed watersheds than in otherwise similar unmanaged watersheds. Statistical analyses of the data support the first and third hypotheses. Stream reaches with steeper valley side slopes tend to have higher wood loads, and reaches in managed watersheds tend to have lower wood loads than reaches in unmanaged watersheds. Results do not support the second hypothesis. Shear stress correlated more strongly with wood load than did stream gradient, but statistical models with valley-scale variables had greater explanatory power than statistical models with channel-scale variables. Wood loads in stream reaches within managed watersheds in the Bighorn National Forest tend to be two to three times lower than wood loads in unmanaged watersheds.     

Energy and carbon balances of wood cascade chains

In this study we analyze the energy and carbon balances of various cascade chains for recovered wood lumber. Post-recovery options include reuse as lumber, reprocessing as particleboard, pulping to form paper products, and burning for energy recovery. We compare energy and carbon balances of chains of cascaded products to the balances of products obtained from virgin wood fiber or from non-wood material. We describe and quantify several mechanisms through which cascading can affect the energy and carbon balances: direct cascade effects due to different properties and logistics of virgin and recovered materials, substitution effects due to the reduced demand for non-wood materials when wood is cascaded, and land use effects due to alternative possible land uses when less timber harvest is needed because of wood cascading. In some analyses we assume the forest is a limiting resource, and in others we include a fixed amount of forest land from which biomass can be harvested for use as material or biofuel. Energy and carbon balances take into account manufacturing processes, recovery and transportation energy, material recovery losses, and forest processes. We find that land use effects have the greatest impact on energy and carbon balances, followed by substitution effects, while direct cascade effects are relatively minor.     

排水管网设计中管材的选择

排水管网使用的各类排水管材种类繁多,性能差异较大.根据排水管材的材质、性能分析,对常用几种排水管材进行了技术经济比较.以实际工程为例,概述了不同施工条件和不同地质条件下排水管材的设计选择方法.     

建筑材料及制品燃烧性能试验规范概述

建筑材料和制品燃烧性试验规范对保证建筑物内人的生命安全和财产安全是极为重要的。笔者对美国、加拿大、欧盟、日本以及中国的建筑材料燃烧性能试验规范进行分析、比较和综述。通过研究认为美国和加拿大对建筑材料燃烧性能的要求和试验方法基本相似,他们主要针对材料的燃烧性、火焰传播进行检测;欧盟于2001年颁布了新的燃烧性分级体系,该分级体系包括专门针对铺地材料部分和针对其他所有建筑构件材料和产品部门;日本采用锥形量热计法(ISO5660)将内装饰材料分为不燃、准不燃和阻燃材料3个等级;我国对建筑材料的试验方法包括不燃性试验方法、墙和天花板内装饰材料的三级分级体系和铺地材料两级分级体系。     

一种机(针)织物与非织造布网络互穿复合材料的研究

本文主要对机织物与非织造布复合材料的网络互穿结构进行了描述,并从材料选择、单体试制、复合工艺方面进行了实践,研制出了较高透气性能和剥离强度的复合材料。     

McCaffrey等估计轰燃前火灾温度方法的改进

在估计室内轰燃前火灾温度的多种方法中，McCaffrey等人提出的方法比较典型。该文根据内衬材料的热惯性对室内火灾的重要影响，在大量实验数据的基础上，对McCaffrey等人提出的这一方法进行了初步和理论上的改进；结合室内火灾的控制因素，对有机玻璃火灾的回归结果进行了进一步改进，提出了估计室内轰燃前火灾温度的新方法。     

Drying of granulated wood ash by flue gas from saw dust and natural gas combustion

At the district heating plant of Kalmar, Sweden an on-line unit for production of granulated wood ash for nutrient recycling on forest soils is being applied. Currently, the granules are dried by hot air from an oil-fired burner. The objective of this work was to investigate how drying by flue gas affects the hardening of granules, or impacts their chemical composition and properties. Ninety-six granule samples were treated by flue gas from natural gas combustion in a laboratory pilot scale flue gas generator. CO₂, CO, O₂, C₃H₈ and NO concentrations were varied during the experiment. Additionally, some samples were treated by flue gas from combustion of sawdust at the heating plant in Kalmar. Drying by flue gases did not affect the chemical composition of granules, but minor effects were seen in their mineralogy. The carbonate content was slightly higher in granules treated with flue gas from natural gas combustion compared to the granules dried by hot air only, when measured by wet chemical methods. Results from XRD analysis imply that the calcite content is higher and the portlandite and arcanite content slightly less in granules treated with flue gas from sawdust combustion compared to the granules dried by hot air only. The results from this investigation showed no negative effects on ash granule composition or physical structure by the use of a flue as a drying medium.     

五大连池老黑山火山的两次喷发活动

老黑山是五大连池火山群中最年轻的火山.通过对老黑山火山锥体结构及其形态分析指出,老黑山火山并非单锥,而是由先、后不同时期形成的两个锥体叠加组成的复合锥,表明它有两次喷发活动.通过对新发掘出的史料的分析,进一步指出,老黑山火山的第一次喷发时间为1720(不是1719年)-1721年,第二次可能为1776年.两次喷发活动的确认为研究老黑山火山喷发历史、喷发过程、喷发危险性评价和灾害预测等提供了新依据.     

木材防腐剂使用与环境安全性

笔者概述了国内外木材防腐剂研究与环境安全性状况 ,讨论了一些常用木材防腐剂的毒性与防腐剂对环境的安全性影响的主要途径 ,分析了木材防腐剂在制备生产中、使用过程中、废弃防腐木材处理以及通过生物体富集和食物链循环产生毒性对环境的污染。介绍了美国木材保护者协会AWPA有关木材防腐处理安全性规范和AWPA木材防腐处理标准 ,并简要论述了低毒和环境无害木材防腐、防蓝药剂的研究进展 ,对国内木材防腐剂研制开发提出了建议。